Similarly to our “PS-701,” the PS-711 has [advance angle function] that compensates delays in operation of the machine, [Timer function] that controls the ON time, [Motion detector function] that monitors rotation signals of the rotary encoder, and so on.
In addition, operability and visibility are advanced with [liquid crystal display] and SSR of all 6CH is common use both AC and DC that achieves better cost-effectiveness.
|・ Available for using the cam output as well as existing mechanical rotary cam output.|
|☆ All cam output of CH is SSR which is for both AC and DC.|
|☆ Contents of setting for all CH are seen at once in the display.|
|・ Enable press machine to be stopped by the motion detector function.|
|☆ Available to find “start-up time”, “SPM”, “stop time” and “stop angle” by using MD input.|
|・ Enable flutter to be come under control by the hysteresis function.|
|・ Advance angle function and Timer function.|
(☆ : New features added to PS-701)
Description of function
Advance angle function
There is operating time on the controlled device such as cylinder when piston (rod) reaches to the stroke end.
Those devices operate delay when compare to setting angle of cam output depending on press SPM and the operating time.
Delay angle due to the operating time increases continuously with the increasing SPM.
PS-711 calculates the delay angle with the rotation speed and the operating time.
And it keeps operating angle of the device steadily in order to control cam output faster than setting angle by the delay angle that we call advance angle.
For the case of ON operating time is 50ms and OFF operating time is 20ms, the delay angle at 60 SPM is 18°and 7°.
When using advance angle, cam output of ON setting angle change from 150° to 132°and its OFF setting angle change from 180° to 173°.
As a result, the device operates at ON 150°and OFF 180°as well as the setting angle.
For the case of controlling air ejection like ON 350°OFF 30°including T.D.C as below figure, if press machine stop at T.D.C, Air ejection is held ON and then expend air(①).
Using timer function like ON 350°OFF 100ms, enable the air to save at T.D.C. because OFF timing of cam output is 100ms after ON timing(②).
Motion detector function
Contents of detection are disconnecting of encoder cable, un-standard states of the timing belt or pulley and so on.
When using motion detector function, need to wire actuation signal of press machine to MD input of PS-711.
Time measurement function
It storages up to four data and deletes it from old data.
Common output for both AC and DC
Available for load-switching AC75～240V, DC5～24V, 1A and acceptable for various devices.
Liquid crystal display
Available to see ON/OFF for each CH of setting angle, advance angle function and timer function in the primary screen of PS-711.
Rotary encoder Dimensions
|Angle display||000 – 359(1 step)|
|Cam (Channels)||6 Channels|
|Cam output||Cam output is SSR or Open collector for each CH.
SSR for AV/DC 75-240VAC, 5-24VDC 1A
Open collector 5-24VDC 100mA
|MD output||Relay 100-240VAC, 5-24VDC 2A|
|Power source voltage||AC100-240V±10%, 50/60Hz|
| Dimensions of
|170(W)×120(H)×146(D) (excluding projections)|
|Weight||2.5kgW(including mounting bracket)|
|Standard attachments|| Instruction Manual
Twenty-core cable (5m)
(Twenty-core cable with connector if CN spec.)
Wire markers (CH1-6 two pieces each)
|Option|| Need to select below parts by choosing order code.